1 Eva Charm Pack
1/4″ wide ribbon
Buttons of various sizes
1 piece of foam core (buy it at your local craft store)
1 package of cork tile squares
I designed my memo board to fit in a 12×16 frame that I already had (I spray painted it to match the fabric). This is the layout that I came up with to fit best in the frame. It seems like you will have extra squares, but you need to have enough give to wrap around the back of the cork and secure to the back of the frame.
Sew the squares together like this. Use 1/4″ seams.
Next assemble your board base.
Cut a piece of foam core to 12×16. Double check that it fits in your frame, it needs to be a bit loose to allow room for the fabric.
To cut the foam core just use your rotary cutter and ruler… use an old blade since it will dull your blade.
Cut and piece the cork squares to fit on the foam core pieces. You can also use your rotary cutter to cut the cork. Using hot glue secure at the corners. Cover the entire piece of foam core.
Next cut 2 pieces of fusible fleece the same size as the foam core. You are making a sandwich. It will look like this from the side. You will have foam core, cork board, 2 layers fusible fleece then your fabric.
If you wish, at this point add a monogram or applique image to one of the squares of your memo board.
Then, iron the fusible fleece onto the backside of your charm square piece on the section of it that you want to SHOW in your frame. DOUBLE CHECK it is in the right spot before you iron it on.
Next trim the fabric so that it is 2″ wider than the fusible fleece on all sides.
Now you will begin to lay out your ribbon. Begin at one corner and working diagonally, start by pinning ribbon the width of your fabric along the seams.
Next, start laying ribbon in the opposite direction. Every place that the ribbon overlaps place a pin. You will put a button here later. (make sure the ribbon is taught)
Using your sewing machine, stitch the ends of each piece of ribbon down. This will prevent it slipping when you hand sew on your buttons.
Using buttons of random sizes, begin hand sewing them on. You will sew them on each place the ribbon overlaps that will show in the frame.
Take your fabric piece and lay it over the cork/foam core piece. Using a hot glue gun, generoulsy glue the fabric and ribbon to the back. Make sure that you put a dot of glue under the ends of each piece of ribbon.
Flip it over and it will look like this! When you are done slip it into your frame and secure. Hang it up and enjoy!
1 memo board per charm pack.